Ascott Corrosion Test Chambers

Corrosion Testing Standards

The test standard summaries are for general guidance only. Though believed to be accurate at the time of writing, this may change over time. So this information should not be used as a substitute for referring to a complete test standard, at an appropriate revision level.
Note: the terms salt spray, salt mist & salt fog are all in wide spread use within corrosion test standards. In this context they can be considered to be equivalent and interchangeable terms.

ISO 16701

Accelerated corrosion test involving exposure under controlled conditions of humidity and intermittent spraying of salt solution

Accelerated corrosion tests to simulate atmospheric corrosion in such environments include cyclic exposure to a wet phase, during which the test object is repeatedly subjected first to a spray of salt solution then to a wet stand-by period for several hours. This is followed by a phase of controlled cyclic humidity conditions, where the test object is subjected to an environment which alternates between high humidity and comparative dryness.

In the first (wet) phase of exposure, the test objects are sprayed for 15 min with a 1% (mass fraction) aqueous solution of sodium chloride acidified to pH 4.2, to simulate the rather acidic precipitation present in industrialized areas, followed by a 1 h 45 min period of wet stand-by. This sequence is repeated three times to give a total of 6 h exposure to wetness. The whole of this first phase of the test cycle is repeated twice a week.

The major part of the test cycle, however, consists of humidity cycling between the two levels of 95 % RH and 50 % RH at a constant temperature of 35°C.

This test is also referred to as a Cyclic Corrosion Test, often abbreviated to CCT.

To select an Ascott chamber suitable for this test click here

 

 

© copyright 2013 Ascott Analytical Equipment Limited