Corrosion Testing Standards

The test standard summaries are for general guidance only. Though believed to be accurate at the time of writing, this may change over time. So this information should not be used as a substitute for referring to a complete test standard, at an appropriate revision level.

Note: the terms salt spray, salt mist and salt fog are all in wide spread use within corrosion test standards. In this context they can be considered to be equivalent and interchangeable terms.

JIS H 8502 M5

金属涂层耐腐蚀性试验的方法

可用于测试电镀涂层在暴露于不同腐蚀性气氛时的相对耐腐蚀性,如下所示:

将试样置于封闭的腔室中,并暴露于连续间接喷洒中性(pH 6.5至7.2)盐水溶液,该溶液以1.0至2.0ml / 80cm² /小时的速率在+35C的腔室温度下落到试样上。 这种气候在恒定的稳态条件下保持。 测试持续时间是可变的。

此测试也称为 NSS 测试

将试样置于封闭的腔室中,并暴露于连续的间接盐水溶液喷雾中,通过添加乙酸而酸化(pH 3.1至3.3),醋酸以1.0至2.0ml / 80cm² /小时的速率落在试样上,在+35C的腔室温度下。 这种气候在恒定的稳态条件下保持。 测试持续时间是可变的。

此测试也称为 ASS 测试

将试样置于封闭的腔室中,并暴露于连续的间接盐水溶液喷雾中,加入氯化铜并通过加入乙酸进行酸化(pH 3.0至3.2),醋酸以1.0至2.0ml / 80cm² /小时的速率落在试样上,在+50C的腔室温度下。 这种气候在恒定的稳态条件下保持。 测试持续时间是可变的。

该测试也称为CASS测试

测试样品涂有腐蚀泥,将其涂在样品表面并使其干燥。 然后将样品置于+38C和80至90%RH(非冷凝)的受控气候下,并静置16小时(1个周期)。 对于进一步的循环,清洁样品并应用新鲜的腐蚀剂。

测试样品暴露在+40C和90%RH的受控气候以及浓度为25ppm或1000ppm的SO2气体中。

小于 200 升的腔室容积不受 JIS H 8502 限制。

有关日本JIS标准的更多信息,请访问; www.jsa.or.jp/default_english.asp