Corrosion Testing Standards

The test standard summaries are for general guidance only. Though believed to be accurate at the time of writing, this may change over time. So this information should not be used as a substitute for referring to a complete test standard, at an appropriate revision level.

Note: the terms salt spray, salt mist and salt fog are all in wide spread use within corrosion test standards. In this context they can be considered to be equivalent and interchangeable terms.

沃尔沃 STD 423-0014

加速腐蚀试验

该标准定义了一种加速腐蚀测试方法,用于在氯离子有显着影响的环境中评估金属的耐腐蚀性,主要是来自海洋来源的氯化钠或冬季道路除冰盐。 它指定了用于进行加速腐蚀测试的测试程序,以受控方式模拟大气腐蚀条件。

一周的主测试周期由两个十二小时的子周期组成,一个具有受控湿度循环;子循环1,其他包括盐溶液应用,子循环2。

子周期1要求在35°C和95%RH下恒定条件4小时,然后将温度升高至45°C,同时在2小时内将湿度降低到50%。 接下来是45°C和50%RH的恒定条件4小时,以及35°C和95%RH的2小时周期。 步骤1:4)温度从45°C降低到35°C

子循环2要求用盐溶液喷洒15分钟,然后将样品保持在35°C下1小时45分钟,同时保持95%-99%RH的设定点,使测试对象保持湿润。 这些步骤按顺序重复,总时间为6小时。 在45°C和50%相对湿度下干燥2小时,然后再干燥2小时35°C,同时保持95%相对湿度。

该测试也称为循环腐蚀测试,通常缩写为CCT。

有关沃尔沃STD标准的更多信息,请访问; volvogroup.com/suppliers